Uni Pin fine line pensPosted: August 23, 2014
After much trial and error I discovered Uni Pin fine liner pens. These are produced by Mitsubishi.
These are the ones that I use the most. I do use other pens for more specific tasks, But Uni Pin are the ones I prefer for both studio work and urban sketching.
I tend to favour 0.05 0.1 0.2 0.3 0.8 But 0.4 and 0.5 are also available. As well as all 7 nib sizes being available in Black, Red and Blue.
Lines are consistent. And there are no problems with ink flow.
The ink dries very quickly on contact with a suitable surface, which needs to be porous, but not on waxed or plasticised surfaces.
The pens work well on the paper of both the Moleskine watercolour and sketch books.
The ink is waterproof, after a second or two, and doesn’t show any bleeding when washed with watercolour
I would say that the lifespan of the pens is fairly lengthy; allowing for pretty much heavy use over about three weeks. But, of course this will vary with the amount of pen work that you do.
As the pen nears it’s, fairly lengthy, lifespan, and the ink begins to run out, lines and ink flow become less defined and the pens can be used for lighter shading work.
They can be bought individually and in packs of five (0.1, 0.2, 0.3, 0.5, 0.8)
At the moment I tend to use specific sizes of pen for specific jobs.
0.8 – For initial outlining
0.3 – For titles
0.2 – For general writing
0.1 – For internal lines and hatching and shading
0.05 – For additional hatching and shading; usually over the top of water colouring.
This post is part of a longer series about the materials that I use.